Dies ist eine alte Version des Dokuments!

Installation und Einrichtung von Ultrix 4.5 einer emulierten (Micro-) VAX unter SIMH

Konfigurationsdatei start.txt für die MicroVAX mit NetBSD unter SIMH

;
; SimH 4.0 Configuration file for MicroVAX 3900
;
; Host System      : DEC MicroVAX 3900
; Operating System : DEC Ultrix v4.5
; Memory           : 64 MiB
; Network config   : XQ: Ethernet, 08:00:2b:04:14:04
; Disks            : RQ0: RA92, 1.5 GB
;                  : RQ1: RA92, 1,5 GB
; CDROMs           : RQ2: iso file
;		   : ultrix-vax-4.5-mode1.ufs = DEC Usltrix Installation Disc
;		   : ultrix-freeware-vax-sept-2002-mode1.iso = Ultrix Freeware CD-ROM Version 2.0 Sept. 2002
;

load -r ka655x.bin

; NVRAM
attach NVR nvram.bin

; CPU config
set CPU 64m
set CPU conhalt
set CPU idle

; configure console to 7-bit only
;set TTO 7b
;set TTI 7b

; Disk drives
set RQ0 ra92
attach RQ0 rq0-ra92.dsk
set RQ1 ra92
attach RQ1 rq1-ra92.dsk
set RQ2 CDROM
attach -r RQ2 ../install-images/ultrix-vax-4.5-mode1.ufs
;attach -r RQ2 ../install-images/ultrix-freeware-vax-sept-2002-mode1.iso
set RQ3 disable

; Tape
set TQ0 disable
set TQ1 disable
set TQ2 disable
set TQ3 disable

; serial port, simulated by Telnet to port 1005
set DZ disable

; printer
;set LPT enable
;attach LPT printer_output.txt

; Disable unused peripherals
set CR disable
set RL disable
set TS disable

; Network interface (08-00-2b is the DEC prefix, the 04-14-02 part is arbitrary)
set XQ MAC=08-00-2b-04-14-04
attach xq tap:tap0

; serial console (launch directly after booting CPU)
;set console telnet=1001

; experimental
;set QVSS en

; boot the system
boot CPU

; Uncomment the line below to enable auto-boot
dep bdr 0